Foxconn H61MD Series - Page 23

HARDWARE INSTALLATION
16
SATA_1/2/3/4
GND
TX+
TX-
GND
RX-
RX+
GND
1
Serial ATA Connectors: SATA_1/2/3/4
The Serial ATA connector is used to connect with
SATA Hard Disk or CD devices which support this
feature.TheSATA_1/2/3/4allowsupto3GB/s
data transfer rate.
Fan Headers: CPU_FAN, SYS_FAN
The fan speed can be controlled and monitored
in the BIOS Setup. These fans can be automati-
callyturnedoffafterthesystementersS3,S4
andS5sleepingstates.
Chassis Intrusion Alarm Header : INTR
The connector can be connected to a security
switch on the chassis. The system can detect
the chassis intrusion through the function of this
connector. If eventually the chassis is closed, the
system will send a message out.
USB 2.0 Headers: F_USB1/2
TheseconnectorscomplywithUSB2.0speci-
cation, you can get USB ports by connecting the
USB module cable to any of these connectors.
CPU_FAN/SYS_FAN
SENSE
POWER
GND
CONTROL
1
INTR
GND
INTRUDERJ
1
VCC
D-
EMPTY
D+
GND
D+
D-
GND
NC
VCC
1 2
109
F_USB1/2