T Series User Manual www.fox-ess.com P a g e | 11
• Not in a direct flow of cool air.
• Not near a television antenna or antenna cable.
• Not higher than altitude of 4000m above sea level.
• Not in environment of precipitation or humidity (> 95%).
• Is well ventilated.
• The ambient temperature is in the range of -20°C to +60°C.
• The slope of the wall should be within ±5°.
• The wall where the inverter is mounted should comply with the following conditions:
1. Is solid brick/concrete or a mounting surface of equivalent strength or;
2. The Inverter must be supported or strengthened if the wall's strength isn't adequate (such
as a stud wall or where the wall is covered by thick layer of decoration)
• Avoid direct sunlight, rain exposure or accumulations of snow during installation and operation.
➢ Space Requirement
➢ Mounting Steps
Tools required for installation.
▪ Manual wrench;
▪ Electric drill (drill bit set 8mm);
▪ Crimping pliers;
To Next Page
Loading...
