35
Foxwell ET2709 OBDII&Battery Tester User’s Guide_ English Version_V1.00
Figure 6-7 Sample Battery Result Screen
The battery is in good condition.
The battery is in good condition but low current. Fully
charge the battery and return it to service.
Fully charge the battery and retest. Failure to fully charge
the battery before testing may result in inaccurate results. If
you still get CHARGE & RETEST message after you fully
charge the battery, replace it.
The battery is almost dead or the connection between the
battery and battery cable is poor. Replace the battery and
retest; or disconnect the battery cables and retest the
battery using the out-of-vehicle test before replacing it.
The battery may be damaged such as broken cell or short
circuit. Replace the battery and retest.
7. Press the Back arrow button to exit the test.
NOTE:
The OBDII&Battery tester keeps the results of last test only. When you start a new test, the last
results are overwritten.
6. DTC Lookup
DTC Lookup menus allows to request DTC definitions stored in the OBDII&Battery tester.
To Look up DTCs:
To Next Page
Loading...
