28
Some types of battery have a single cover for all the inspection plugs.
To access the elements, use a lever as shown in the figure.
Check tension and state of the auxiliary member
drive belt
Only proceed with the engine stopped and at a low temperature, so
as to avoid the risk of burning.
Refers to engines with automatic tensioning devices
Remove any casing protecting the pulleys.
Check that the belt is not torn or worn, and that there are no
lubricants or fuel on it. If this is not the case, replace them.
At the same time, make sure that the tensioning device is working
properly, proceeding as indicated in the figure.
Replace the guard casing in its housing, and lock all the retaining
elements.
To Next Page
Loading...
