Framery One
1.7.1 Installation, maintenance, and disassembly
WARNING!
To reduce the risk of burns, fire, electric shock, or injury to persons,
obey the following:
Use cut resistant safety gloves during the installation, maintenance, or
disassembly of the product.
Use steel toed safety boots during the installation, maintenance, or
disassembly of the product.
Read and understand the instructions and plan your work beforehand.
Obey all local rules and regulations regarding workplace safety.
Keep the work site tidy and free from debris throughout the installation,
maintenance, or disassembly process.
Do not climb on top of the product or place any load on the roof of the
product.
If the optional casters are not engaged, do not move the finished product by
pushing.
The product is very heavy. Moving the product after installation without
engaging the optional casters is not allowed.
1.7.2 Electrical safety
Input for the electrical system: 100-240 VAC (10 A) 50-60 Hz
The maximum load for the electrical system is 6.6 A.
DANGER!
To reduce the risk of electric shock, obey the following:
Disconnect the power cord from the power outlet before starting any
cleaning, maintenance, or disassembly procedures.
The power cord serves as a power disconnect device for pluggable
equipment. The power outlet shall be located near the equipment and shall
be easily accessible.
WARNING!
To reduce the risk of burns, fire, electric shock, or injury to persons,
obey the following:
Connect the power cord to a properly grounded outlet only.
Changing the door handedness
info@frameryacoustics.com
7
To Next Page
Loading...
