4 Installation & Operation Manual
INSTALLATION GUIDE
7. Connect original braided hose attached to tap onto the head assembly outlet.
Make sure all ttings are tight and braided hose is kink free.
8. Restore the water supply and check for leaks. If leaks occur, undo cartridge and
check the cartridge is seated properly.
9. Run the system for at least 10 minutes (turn on mixer tap to run cold water) to
remove carbon nes. Water may appear milky, but this is normal and is only tiny
air bubbles that will clear after a short period.
Figure 1
Head
Assembly
Also Includes
Extending Kit
Existing Mixer Tap
F1-R Cartridge
HOT COLD
Braided Hose
Non-Return Valve
To Next Page
Loading...
Need help?
General
