Franke F1 User Manual

6 Installation & Operation Manual
PERFORMANCE DATA
• Be sure to change the lter cartridge at least every 56,000 litres or 12 months
which ever occurs rst; or whenever you detect a change in taste, odour, or
decrease in ow.
Caution: Do not use with water that is microbiologically unsafe or of unknown
quality without adequate disinfection before or after the system.
Performance Data
Substance Guidelines*
Average
Inuent
Concentration
Max Efuent
Concentration
Min Percent
Removal
Average
Efuent
Concentration
Average
Percent
Removal
NSF Standard 42 Drinking Water Treatment Units
Chlorine
(56,775 L)
5 - Health
0.6 - Aesthetic
2.1 0.3 50% 0.25 >95%
Test Parameters
Hardness, Total mg/L 140
TDS mg/L 330
Temp deg C 20
Turbidity NTU ND (0.1)
pH 7.61
*Australian Drinking Water Guidelines - 1996
ND = Not Detected
This appliance meets the domestic water treatment appliance Standards AS/NZS3497 for the fol-
lowing water treatment processes:
Class Treatment type Function Pass
I Microbiological Status Will stop bacteria increasing, but will
not remove them unless II(a) is passed
N/A
Bacteriostatic
II Microbiological Treatment
II (a) Bacteria Removal Will remove or inactivate bacteria N/A
II (b) Virus Removal Will remove or inactivate virus N/A
II (c) Protozoa Removal Will remove or inactivate
Cryptosporidium and Giardia, but will
not remove or inactivate bacteria and
virises unless II(a) and II(b) is passed
N/A
III Turbidity & Particulate Reduction Reduces cloudiness YES
IV Taste & Odour Reduction Reduces taste & odours YES
V Chemical Treatment Decreases chlorine YES

Franke F1 Specifications

General

Brand	Franke
Model	F1
Category	Water Filtration Systems
Language	English