– 12 –
CM FS 45 BK
EN
OPERATION
Switching on the first time
Connect the appliance to the mains supply (see
chapter Installation) and switch on the appliance
with the main switch (see A page 4).
The first time you switch on the appliance with
the main switch and every time that it is plugged
in, the appliance executes a SELF-DIAGNOSIS
action.
Then the appliance switches off.
To turn it on, press the On/Stand by button (Aa)
on the left site underneath the control panel.
IMPORTANT
Coffee has been used to factory test the
appliance and it is therefore completely normal
for there to be traces of coffee in the mill.
Customise water hardness as soon as possible
following the instructions in the “Setting water
hardness” section.
When using the appliance for the first time,
you need to make 4-5 cups of coffee and
4-5 cappuccinos before the appliance gives
satisfactory results.
Each time you turn the coffee maker on by the main
switch (A), it performs a SELF-DIAGNOSIS cycle
and then goes off. To turn it on again, press the On/
Stand by button (Aa).
Start the appliance with the On/Stand by button
(see ‘Aa’). The appliance displays FILL TANK in
different languages.
9 Extract the water tank, rinse and fill with fresh
water without exceeding the MAX line.
9 Replace and push as far as it will go.
Set the required language.
When the message PRESS OK TO SET TO
ENGLISH is displayed, press and hold the touch
key (5) for about 5 sec.
– If you set the wrong language, follow the
instructions in the “Setting the language”
section.
– If your language is not available, select
one from those displayed. The instructions
refer to the English version. Then follow the
instructions displayed.
Place a cup under the hot water spout. If the hot
water spout is not inserted.
The appliance displays INSERT WATER SPOUT.
Place the hot water spout if it is not there.
The appliance displays: HOT WATER PRESS OK.
Press the touch key (5) and after a few
seconds a little water comes out of the spout.
The machine now displays TURNING OFF PLEASE
WAIT and goes off.
Extract the appliance by pulling it out using the
handles.
Open the lid and fill the container with coffee
beans, then close the lid and push the appliance in.
The coffee maker is now ready for normal use.
To Next Page
Loading...
Need help?
General
