– 20 –
CM FS 45 BK
EN
Cleaning the milk container (N)
Always clean the tubes inside the milk container when
you prepare milk. If there is still milk in the container,
do not leave it out of the refrigerator for longer than
strictly necessary. Clean the container each time you
prepare milk as described in the section “Making
cappuccino”.
Note: All components can be washed in a
dishwasher, placing them in the top basket of the
dishwasher.
Turn the milk container lid clockwise then remove it.
Remove the milk spout (S) and intake tube (M).
Remove the frothed milk regulator (F) by pulling it
outwards.
Wash all the components thoroughly with hot
water and mild washing-up liquid. Make sure there
are no milk residues left inside the holes (H) and
the groove (G) on the fine end of the frothed milk
regulator (F).
Check that the intake tube and spout are not
clogged with milk residues.
Replace the frothed milk regulator, milk spout and
intake tube.
Replace the milk container lid.
Cleaning the spouts
Clean the spouts on the milk container every time
after heating milk or making cappuccino. Otherwise,
remains of milk may set hard.
Place a container under the milk dispenser pipe
and press on the CLEAN button (N3) on the milk
container for at least 5 seconds. The display
shows CLEANING!
Risk of scalding from steam and hot water
escaping from the milk dispenser pipe.
To Next Page
Loading...
Need help?
General
