Franke Frames CM FS 45 BK User Manual

– 23 –
CM FS 45 BK
EN
FAULT CAUSE SOLUTION
Water comes out of the spouts
instead of coffee.
Too much preground coffee was
inserted.
Remove the brewing unit and
carefully clean the insided of
the machine (see “Cleaning the
coffee machine” and “Cleaning
the brewing unit”). Repeat the
process using a maximum of
2 level measuring spoons of
ground coffee.
Ground coffee was used (instead
of coffee beans) and the machine
will not dispense any coffee.
Preground coffee was inserted
whilst the machine was switched
off.
Remove the brewing unit and
carefully clean the insided of the
machine (see “Cleaning the coffee
machine” and “Cleaning the brewing
unit”).
Repeat the process with the
machine switched on.
Coffee does not come out of the
spouts on the coffee dispenser
but out of the service door at the
side.
The holes on the coffee dispenser
are blocked with dried on coffee.
The swing drawer on the inside of
the service hatch is blocked and
will not move.
Remove the dried on coffee with a
needle (see “Cleaning the
coffee machine”).
Carefully clean the swing drawer,
particulary in the area around the
hinges so that these continue to
move.
Milk is frothed up too much
or too little.
Wrong setting of the slider on the
lid of the milk container.
If the milk is not frothy enough,
the milk container may not be
correctly in place.
You can set the amount of froth
on the milk to any level using the
slider on the lid:
CAPPUCCINO (very frothy milk) or
CAFFE LATTE (not so frothy milk).
Put the milk container correctly in
place.

Franke Frames CM FS 45 BK Specifications

General

Brand	Franke
Model	Frames CM FS 45 BK
Category	Coffee Maker
Language	English