6
Your chiller has a dial for water temperature control.
For colder water: Turn it clockwise (to the right).
For less cold water: Turn it counterclockwise (to the left).
To shut down the chiller: Turn the dial to the Off position at full counterclockwise (extreme left).
Allow one hour to obtain chilled water.
C hille r Use
Setting the Control
1
.
Unplug the chiller.
2
.
Shut off water supply to chiller.
3
.
Open faucet to release pressure.
4
.
Disconnect the water lines attached to the chiller by
depressing collet on easy to connect fittings.
5
.
Tip chiller to the left side (power cord side) and drain water
into a large container.
6
.
Set chiller in its normal upright position for storage.
Draining the Chiller
1
.
Shut off water supply to chiller.
2
.
Put chiller in position, allowing a 2” (5 cm)
space around the side and top.
3
.
Connect wat er lines as described in the ‘’Install the
Chiller’’ section.
4
.
Slowly open main water supply valve and open faucet
until w ater flows.
5
.
Plug in chiller and set dial to desired water temperature.
(See the “Setting the Control” section).
Reconnecting the Chiller
If the chiller does not operate
,
check for these conditions first:
Has the circuit breaker tripped or has a house fuse blown? Is the Temperature Control set to the “Off” position?
Is the power supply cord plugged into a grounded Has the water supply been turned off?
3 prong outlet?
Is the electrical outlet controlled by a switch?
Before calling for service
...
To Next Page
Loading...
