INSTRUCTIONS FOR USE
FUNCTION SWITCH
Fig. 7
A. Lighting.
B. Ventilation mode. The extractor fan runs
at low speed for 60 minutes.
C. Speed 1 on fan motor.
D. Speed 2 on fan motor.
E. Speed 3 on fan motor. If the button is
held down for 2 seconds, the fan goes
into intensive mode. After 7 minutes,
the fan motor returns to the previously
set position. The fan can be started and
stopped with the B-E buttons.
It is a good idea to turn on the hood before
starting to cook, as this prevents cooking
smells spreading into the room. Adjust the
speed of the hood depending on the type of
food you are preparing. If possible, allow
the hood to run at a low speed for a few mi-
nutes after you’ve finished cooking. You
may also wish to run the hood on the low
setting when the oven is in use or after us-
ing the dishwasher.
CARE AND MAINTENANCE
Cleaning
The cooker hood should be cleaned with a
damp cloth and washing-up liquid. The filter
must be cleaned twice a month, with nor-
mal usage.
Fig. 8
Remove the grease filter by opening the
snap, Fig. 8. Handle the filter gently, be ca-
reful not to bend them.
Soak the filter in a solution of warm water
and washing-up liquid. The filter can also be
washed in a dishwasher.
Refit the grease filter after cleaning, make
sure they snap firmly into place.
Fig. 9
Motor core and hood interior must be clea-
ned at least twice a year.
The motor core is removed by first discon-
necting the contact on the side of the mo-
tor unit, Fig. 9A. Rotate the latches, Fig. 9B,
that lock the motor core in place. Pull the
unit outwards so that it is freed from the
pins, and then downwards.
Attention!
The motor core should not be washed or
exposed to moisture! The cooker hood
should be cleaned with a slightly damp
cloth and washing-up liquid.
14
991.0520.120/D000000006918/180382/2021-10-08
To Next Page
Loading...
