UVC-System Instruction manual
6
1. Safety-related and general instructions 6
2. Installation 7
2.1 Obligatory instructions 7
3. Connection instructions 7
3.1 Electrical connection 7-8
3.2 Exhaust air 8
4. Operator instructions 8
4.1 Operating instructions 8
4.2 Switching the appliance on/off 9
4.3 Setup menu 10-12
5. Cleaning and maintenance 14-17
5.1 Regular cleaning 14
5.2 Long-term shutdown 15
5.3 Customer service 15
5.4 Maintenance 15
5.5 Picture instructions 16-17
6. Disposal of UVC lamps 18
7. Malfunctions 18-19
Replacement parts 20-22
Electrical wiring diagram 23
1. Safety information
Before using the appliance for the first time, the notices in this manual concerning safety in
operation, use and maintenance must be carefully read and implemented.
i
Read these instructions through carefully and retain them for future reference.
Attention: The appliance must not be The A-evaluated equivalent continuous sound
cleaned with direct water jets or a high- pressure level at the workstations of the
pressure water jet. operational personnel is under 70 dB (A).
! The UVC lamps "F" are located in the ! Please also pay attention to the information
internal housing area of the UVC system. in the Startup / Operation sections.
! In operation as directed, these lamps are
1. General information:
hidden by the housing and not visible from
! Disconnect the appliance from the mains
outside.
power supply in the case of failures or
! In this condition, no hazards exist.
operating faults.
! The UVC lamps "F" generate UVC light. In
! Allow necessary repairs to be performed by
the absence of protection, this is hazardous
qualified technical personnel only.
to the eyes and skin.
! Use original replacement parts only.
! Therefore, it is a basic principle that the UVC
! Clean the UVC system according to Chapter
system must be shut down in all cases
5.
before the Franke aerosol filters of the
universal hood or the mesh filters "M" are
! The failure to respect these specifications
removed from the UVC system.
may impair the safety of the appliance.
! Maintenance work must only be performed
by authorized technical personnel.
! Employees entrusted with simple cleaning
work, for example the cleaning of the UVC
lamps "F" or the mesh filter, must receive
training in advance and must be notified of
the possible hazards.
USAUSA
To Next Page
Loading...