10
interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment o and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
1) Reorient or relocate the receiving antenna. 2) Increase the separation between
the equipment and receiver. 3) Connect the equipment into an outlet on a circuit
dierent from that to which the receiver is connected. 4) Consult the dealer or an
experienced radio/TV technician for help.
Note: This unit was tested with shielded cables on the peripheral devices. Shielded
cables must be used with this unit to ensure compliance with the Class B FCC limits.
Note: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modications to this equipment. Such modications could void the
user’s authority to operate the equipment.
FCC Radiation Exposure Statement :
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
18. IC notice
This Class B digital apparatus complies with Canadian ICES-003. Cet appareil
numérique de la classe B est conforme à la norme NMB-003 du Canada.
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device. Le présent appareil est conforme
aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas
produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement.
19. EU notice
This product is CE marked according to the provisions of the R & TTE
Directive(1999/5/EC). Hereby, Franklin Electronic Publishers Inc., declares that
this product is in compliance with the essential requirements and other relevant
provisions of Directive 1999/5/EC. A copy of the Declaration of Conformity is attached
on the last page of the manual.
0700
20. Disclaimer of Warranties
Except as specically provided herein, Franklin makes no warranty of any kind,
express or implied, with respect to this product.
To Next Page
