FranklinWH System User Manual
8
Partial Backup
If you select a partial backup configuration, you need to identify backup loads during
system configuration. Connect the backup loads (except for the Smart Circuit loads) to the
backup port of the aGate, and connect the non-backup loads (non-essential loads) to the
non-backup ports of the aGate. If the grid fails, the FranklinWH system will only power
the backup loads during the outage.
NOTE
A combiner box is required for multiple aPower units’ installation, except
when 2 aPower units are installed with Quadplex breakers.
To Next Page
Loading...