FranklinWH System User Manual
2
Safety Instructions
General Information
The aGate and aPower are electrical equipment that, when used improperly, can
present a risk of electrical shock and fire, and misuse may void the warranty.
Only FranklinWH Certified Installers should install, maintain or replace aGate and
aPower equipment or wiring. They must wear personal protective equipment (PPE)
during operation.
If the aPower battery is leaking electrolyte, smoking, or on fire, if it is safe to do so,
disconnect the AC power from the FranklinWH system and turn off the aPower
switch on the side of the aPower to stop the aPower from charging and discharging.
It is strictly forbidden to install, maintain or handle FranklinWH equipment
outdoors during bad weather such as thunder, rain, snow and high winds.
It is strictly forbidden to work on or operate the FranklinWH equipment alone.
For safety, make sure that there is someone around you who can help.
During use, storage, and transport, ensure that the ambient temperature of an
aPower does not exceed 130 °F (55 °C), that it is not near flammables, and that
the cooling system and vents are not blocked.
During the transport and handling of aGate and aPower units, extreme care is
required to avoid dropping, bumping, kicking, or inverting the equipment.
Only use parts or accessories purchased from FranklinWH or a FranklinWH-
certified party.
Do not paint any part of an aPower or aGate unless the paint surface of the
equipment housing is accidentally damaged during transport, installation or
maintenance. The damaged part can be repaired with paint or topcoat of the
same color.
If any equipment failure occurs, please contact your installer or after-sales service
provider for support. Do not attempt to take apart, repair and/or modify an aGate or
aPower without the authorization of FranklinWH. Otherwise, it may lead to safety
hazards and void your warranty.
To Next Page
Loading...