TPA600 Rev170623
10
PROGRAMMING
To access the program functions, to view and change parameter settings, a password
is entered. The code for the Engine Monitoring Display is 2222.
Note: To exit the programming mode press the SILENCE and MENU buttons
together. (The program mode times out after ten seconds if no buttons
are pressed.)
Program Access
1. Press the SILENCE button and hold it until the RPM display shows four
dashes – – – – . Release the button.
2. Press the MENU button within three seconds. The RPM display shows
the number 1000. Each time the MENU button is pressed the rst digit
increments by 1. Set the rst digit to the desired number.
3. Press the SILENCE button to move the curser to the next digit. Press the
MENU button to change the digit.
4. Repeat step 3 and enter the password code 2222.
Result: When a correct password code is entered P 0 1 shows in the
RPM display.
5. Press the SILENCE button to scroll through the program (P) codes.
6. Press and hold the MENU button for three seconds to enter the
programming mode to view and change parameter settings.
7. While the parameter or value is ashing, press and hold the MENU button
to change a selectable parameter or numerical value. Press the MENU
button again to change the digit, or scroll through values. Next press the
SILENCE button to move the cursor to the next digit to be changed, or the
next window option.
8. Repeat steps 5 through 7 as necessary.
9. To exit the programming mode, press the SILENCE button to scroll through
the P-codes until P99 is reached. At P99, the display will read 'END'. Press
and hold the MENU button to fully exit the Programming mode and return
to normal operation.
To Next Page
Loading...