FRC Turbofoam TFC200 - Figure L3. Foam Pump Assembly Dimensions

TFC100 Rev180215
44
Motor Fan Intake
Requires 1/2" Clearance
Figure L3. Foam Pump Assembly Dimensions
8 7/8"
10"
19 1/2"
Front
View
Side
View
Typical 1.6, 2.1 and 2.6 GPM
Foam Pump Assembly
UP
8 7/8"
23 1/2"
10 1/4"
Side
View
Typical 3.5, 5.0, 6.2, 6.5 GPM
Foam Pump Assembly
Front
View
UP
Installation Notes:
• Foam Pump Assembly must be mounted in an upright position.
• Not all mounting holes are easily accessible on every foam pump assembly.
• Remove and replace the pump oil reservoir red shipping plug with the yellow vented cap/dip stick.
• Check the oil level (use the sight glass or dip stick).
• A strainer must be installed along the pump input line (refer to Plumbing).
• The calibration bypass valve needs to be accessible.
• Larger motors (2.1, 3.5, 5.0, 6.2, 6.5 GPM ) have a fan at the rear and require 1/2" fan intake clearance.