12
FREECOM CLASSIC CD-ROM / CD-RW
GB
3
CHAPTER 3: Installing the Writing Software
After installing the USB drivers, your Freecom CLASSIC CD-RW is now able to read
CD-ROMs.
To record a blank CD, you must first install the writing software.
We recommend
using the software which has been provided with your drive.
Note: If you wish to use other software, please find out from the
supplier whether his products support the Freecom CD-RW Recorder.
3.1 Special Instructions before Writing a CD
• You should realize that writing CDs is principally a compact data transmission
procedure which can be disrupted by even the smallest mechanical distur-
bance.
• Never clean the CD-R/CD-RW drive with a commercially available CD or a CD-
ROM cleaning set. This can damage the drive.
• Recordable CDs (blanks) are more sensitive than commercially available CDs.
Use only a solvent-free, non-abrasive marker when writing on a CD.
• Do not stick any conventional labels on the CD-Rs, since the adhesive can
attack the medium. Special labels for CD-R media are available in retail
computer stores. Never remove a label from a CD-R media otherwise you will
damage the protective layer and make the CD-R unusable.
• The drive recognizes the medium as soon as it is placed into the drive. CD-R
media are compatible with the vast majority of CD-ROM drives and CD audio
players and work in most DVD-ROM drives.
Recommendation: For optimal results, use Freecom blank CD’s, avail-
able via your local reseller or at www.freecom.com.
To Next Page