EasyManuals Logo

Freedom Easy User Manual

Default Icon
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
7. Remove DCR programming
1. Log into the Configuration Manager of the Commander/RubyCi.
2. Navigate to Forecourt > Fuel > Fuel Config Pending > Fueling Positions.
See figure 5 on page 15.
Uncheck ‘DCR In Dispenser for each upgraded fueling position and SAVE.
3. Navigate to Tools > Managed Modules > Current Configurations > Host Names -
sitecontroller > Select Module - DCR Driver > DCR Positions Advanced Settings.
See figure 6 on page 15.
Remove the channel programming for each upgraded DCR Position and SAVE.
4. Initialize Fuel and DCR’s.
The Easy Pump should now be operational at each upgraded fueling point.
Once all fueling points have been upgraded to
The Easy Pump, remove the DCR driver.
5. Navigate to Tools > Managed Modules > Current Configurations > Host Names
sitecontroller > Select Module DCR Driver > DCR Channel 01 Advanced
Settings. See figure 7 on page 15.
Remove DCR Family type
Remove Port Name
Uncheck Enable and SAVE
6. Initialize Fuel and DCR’s, including Drivers.
14
Freedom Easy Pump
Freedom Easy Pump: Mako

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Freedom Easy and is the answer not in the manual?

Freedom Easy Specifications

General IconGeneral
BrandFreedom
ModelEasy
CategoryWater Pump
LanguageEnglish