The turning pipe can be taken apart easily for carrying of storage.
2. Power Switch
(1)
The power switch is used to turn on and off the power, when the
power switch is on the Freego will finish the initialization-settings.
(2)
It is dangerous to stand on Freego without turning on the power.
3. Pedal Switch (SAFE switch)
(1)
The pedal can be active up or down, it has a built in safety switch.
Freego can check whether someone on scooter by pedal switch.
(2)
The pedal switch has a safety feature, which if the driver leaves the
Freego; the pedal switch will reset and then will stop after 2 seconds.
4. LCD displayer on Pedal
Shows the power percent left in the battery.
CHAPTER III
Getting Started
1. The Right Starting Operation
Hold the turning pipe/handle bar with one hand, keeping the pedal upright,
turn on the power making the green light stay on continuous, indicating
starting is successful (refer to picture 2,3,4). Then after hold the handlebar
firmly with two hands (refer to picture 5). Make sure the pedal is placed
upright and then turn on the power switch. Because Freego will considers
the current pedal position as its original position setting. This is a very
important step. If the original position is not set correctly, it will upset the
vehicle’s balance during driving
To Next Page
Loading...
