10
Operation
Before first use:
1. Read all the points in the paragraph ’Safety instructions’.
2. Connect the power adapter to the charging port and wall
outlet, the indicator on the adapter will illuminate in red.
Note: Connect the power adapter to charging port firstly.
3. When the charging is complete after 4 hours, the
indicator on the adapter will illuminate in green.
Note: Charge the battery fully the three first times. Do not
charge it over 6 hours.
Steer the E-scooter:
1. Long press the Power/ Light button for 3 seconds to
active or turn off the machine.
2. Single press the Power/Light button to switch on/off the
front light.
3. Click the up and down button to change the switch gear
between mode1, 2 and 3.
Gear 1: maximum speed is 8 km/h.
Gear 2: maximum speed is 15 km/h.
Gear 3: maximum speed is 20 km/h.
4. To start the scooter, first use your feet to get up to 3km/h
and then use the throttle to accelerate. Press the throttle
lightly to accelerate the vehicle, and press it harder the
speed goes faster. The dash board will show the speed
per hour.
Note: Be accelerate according to the proficiency to
assure safety, and accelerate gradually for initial use.
5. Lightly hold the brake to decelerate, hold harder and the
deceleration more obvious.
Note: Be brake in advance when the barriers are in front.
6. The dash board will show the speed, single trip
kilometers and battery power status.
7. The scooter has cruise control function.
´ If the accelerator drives in a fixed speed for 3 seconds,
the sign “ ” will appear in the dash board, the scooter
will move in the fixed speed even though loosen the
accelerator, it won’t decelerate until brake.
To Next Page
Loading...
