8. Insert the aileron servo wires into the 9. Apply 5-minute epoxy to the bottom of
ho
les in the fuselage and route to Rx. the vertical stabilizer with the foam insert
on the right side removed.
10. Carefully install the vertical stabilizer onto the fuselage, making sure the elevator tube
goes into the exit slot. Be sure not to foul the pushrod opening with glue.
11. Epoxy the area where the foam insert goes and carefully install the insert while
making sure the elevator tube goes into the exit slot.
F9F Panther
Item No.:F1701 -4-
To Next Page
Loading...
