Level control
Fill theair suspension via
connection28onthe elec-
tronicpressure supply unit
Maximum
1250 kPa
Compressed-air reservoir
Information on thecompressed-air
reservoir
For theinitial purchaser and other users
Accompanyingdocumentation in accordance
with Directive 2009/105/ECofthe European
Parliaments and Council and in accordance
with the technical standard EN 286-2.
The reservoir is:
a
–
only intended for use in compressed-air
systems and auxiliary equipment on
motor vehicles and their trailers, and is
only to be used to hold compressed air.
b
–
to be marked for identification with a
works number and the reservoir manufac-
turer’s name, together with the principal
operating data and the EC mark; see the
identification plate or engravings directly
on the reservoir wall.
c
–
to be manufactured with a"Declaration of
conformity" in accordancewith Article 12
of Directive 2009/105/EC.
d
–
to be secured to the vehicle by retaining
straps (clamps).
In the case of aluminum reservoirs, con-
tact surfaces must be designed to inhibit
corrosion or mechanical damage. Secur-
ing straps are to be positioned in such a
way that they do not come in contact with
the base connectingseams; the reservoir
is not to be subjected to any stress that
would jeopardize operating safety.
Coatings applied to aluminum reservoirs
must not contain lead, and the top coat of
paint must only be applied over asuitable
primer coat. Steel threaded connections
for aluminum reservoirs must have acor-
rosion-proof coating.
—only to be cleanedusing non-alkaline
cleaning agents (aluminumreservoirs).
—tohave the interior visible through the
threaded connections.
—tobeemptied at regular intervals to pre-
vent the accumulation of condensation
(drainage ring nut at the lowest point of
the reservoir).
e
–
to require no maintenance if item dis
complied with.
f– no welding, heattreatment or other oper-
ation relevant to safety is to be performed
on the pressure-bearing walls of the reser-
voir (casing, base, ring nuts).
g
–
the internal supply pressure may exceed
the maximum operating pressure P
s
by no
more than 10% for abrief period.
Daimler AG
Compressed-air reservoir identifica-
tion plates
Aluminum reservoir
Identification plate, compressed-air reservoir
(example: aluminum reservoir)
:
Manufacturer: SAG (Austria)
;
MB part number
=
Maximum operating pressure (bar)
?
Volume (liters)
A
Testing establishment code number
B
Year of construction
206
Compressed-air reservoir
Technical data
To Next Page
