R
To prevent ashort circuit, switch the lighting
system off and the ignition lock to position
g before replacing abulb.
R
Wear eye protection and gloves when
removing defective bulbs.
R
Always replace defective bulbs with the
specified new bulbs, i.e. those with the cor-
rect wattage and voltage.
R
Only hold bulbs with aclean, lint-free cloth
or asimilar item. Do not work with wet or
greasy fingers.
R
Test the contacts for corrosion and clean
them if necessary.
R
Check that all seals are positioned correctly,
and replace damaged seals.
R
If the new bulb does not light up, consult a
qualified specialist workshop.
R
Have the following bulbs replaced at aquali-
fied specialist workshop:
-
LED high beam
-
LED low beam
-
LED side marker lamps
-
LED perimeter lamp
-
LED identification lighting
Changing bulbs
Overview of bulbs and lamps
Front lamps
Low-beam head-
lamps
LED module
High-beam head-
lamps
LED module
Frontturn signal
lamps
PY21 W24V
Side marker lamps LED module
Perimeter lamp LED module
Identification lighting LED module
Interior lighting
Roof lamp: interior
lighting
P18 W24V
Roof lamp: reading
lamp
R10 W24V
Roof lamp: nightlight EBS-R4 1.2 W24V
Additional bulbs
Side marker lamps LED module
Exit light W5 W24V
Front bulbs
General information
The following bulbs can be replaced:
R
Frontturn signal lamps
i
Daimler Trucks North Americarecom-
mends that you have headlamp bulbs
replaced at aqualified specialist workshop.
Front turnsignal lamps
X
Unscrew screw : and remove the turn sig-
nal lamp.
X
Turn bulb holder ; counter-clockwise,
applying light pressure, and remove it.
52
Lighting system
Driver's workstation
To Next Page
Loading...
