H. Rubber Sealing Strip
I. Sealing Gaskets (up and down)
J. Vacuum Chamber
K. Sealing Wire / Heater
L. Cutter
How to Use the bag cutter
In the back of the appliance is the bag cutter. This accessory easily lets you get an even and neat cut. Frayed,
lopsided, or crooked edges could prevent the generation of vacuum and interfere with the sealing process.
1. Open the cutter bar. To do this, push the black handles at both sides of the cutter bar to the rear of the
appliance.
2. Insert the bag between cutter bar and the base of the appliance. Then press the cutter bar in place again, until
it clicks shut.
3. Push the slider of the cutting bar to the opposite end of the cutter bar.
4. Pull the bag out from under the cutter bar.
How to Make Custom Sized bags
1. Pull enough bag material to hold item to be vacuum packaged, plus 2 inches. With the cutter, cut the desired
To Next Page
Loading...