FRIATEC FRIALEN - Safety and Warning Information; Safety Symbols and Advice; Application Areas for FRIALEN Fittings

3
1. Safety
1.1 Safety advice and tips
The following warning symbols are used in these assembly instructions:
DANGER!
Describes impending danger!
Non-observance of this warning may lead to serious damages to health and
objects.
WARNING!
Describes a dangerous situation!
Non-observance of this warning may cause minor injuries or damage to
objects.
IMPORTANT!
Describes advice and other useful information!
2. Areas of Application
FRIALEN
®
Safety Fittings are used for weld joints at pressure pipes made
of polyethylene in the dimensions SDR 17.6 to SDR 11 for use in gas and
water supply, pressure drainage, industry and landfill construction.
For processing of pipes SDR > 17.6, please call us.
When operating with other media than water and natural gas, please contact
our application engineering department.
IMPORTANT!
The information and processing instructions mentioned on the fitting or
enclosed shall apply predominantly.
FL_2104_8_GB_II_08.p65 25.03.2008, 9:48 Uhr3