Fridgemaster MC55264DS - Reversing the Door

The side at which the door opens can be
changed, from the right side (as supplied)
to the left side, if trequired.
Warning! When reversing the door, the
appliance must not be connected to the
mains. Ensure that the plug is removed
from the mains socket.
Tools you will need
Left Hinge Cover
8mm wrench
8mm socket wrench
Monkey wrench
Thin-blade
screwdriver
Cross-shaped
screwdriver
2. Use a putty knife or thin-blade
screwdriver to prize the screw hole cover
which is at the top left corner of the
refrigerator, and the upper hinge cover
which is at the top right corner of the
refrigerator.
Reversing the door
Note: If required you may lay the
refrigerator on its back in order to gain
access to the base, you should rest it
on soft foam packaging or similar
material to avoid damaging the
backboard of the refrigerator. To reverse
the door, the following steps are
generally recommended.
1. Stand the refrigerator upright. Open
the upper door to take out all door
racks and tank(to avoid damage) and
then close the door.
Water tank
Door racks
Putty knife
3. Unscrew the special flange self-tapping
screws which are used for fixing the right
upper hinge part by a 8mm socket driver
or a spanner (please support the upper
door with your hand when doing it) .
right upper hinge part
special flange
selftapping screws
4.Remove the upper hinge axis, transfer it
to reversed side and tighten securely, then
put it in a safe place.
①
② ③
5. Remove the upper door from the
middle hinge by carefully lifting the door
straight up.
NOTE: When removing the door, watch
for washer(s) between the center hinge
and the bottom of the freezer door that
may stick to the door. Do not lose.
Reversing the door
8
upper hinge
cover (right)
screw hole cover