To Next PageTo Next Page
Need help?Do you have a question about the Friedrich Breeze WFH36Z193C and is the answer not in the manual?
General| Model Number | WFH36Z193C |
|---|---|
| Brand | Friedrich |
| Product Line | Breeze |
| Type | Heat Pump |
| Cooling Capacity (BTU/h) | 36000 |
| Heating Capacity (BTU/h) | 36000 |
| SEER Rating | 19 |
| Phase | 1 |
| Refrigerant Type | R-410A |
| EER | 12.5 |
| Voltage | 208/230V |
General safety guidelines and hazard symbols for installation and service.
Details on electrical hazards, explosion hazards, and safety warnings.
Specific warnings about electrical hazards and personal protective equipment (PPE).
Hazards related to refrigeration system repair, mechanical aspects, and property damage.
Detailed technical specifications for outdoor units, including electrical and fan data.
Quantity per container, test conditions, and installation notes.
Technical specifications for indoor units, including power, coil, fan, and dimensions.
Indoor unit test conditions, sound pressure, and installation notes.
Crucial safety warnings for installation, including electrical hazards and proper grounding.
Additional safety instructions regarding electrical covers, wiring, and refrigerant handling.
Further safety precautions, including Proposition 65 warnings and operational advice.
Common troubleshooting steps for no operation or poor cooling/heating.
Safety notices for installation, emphasizing grounding and proper electrical connections.
Requirements for pipe material and connection procedures for refrigerant piping.
Procedures and precautions for performing the post-installation test run.
Requirements for pipe material, dimensions, and maximum length.
Steps for cutting, burring, and connecting copper pipes for refrigerant lines.
Flowchart detailing the triple evacuation process for the refrigerant system.
Final checks and operational procedures for the test run, including compressor protection.
Common troubleshooting scenarios like no start-up, frequent stops, poor performance, and water leakage.
Table of fault codes for outdoor units, their descriptions, and possible causes/solutions.
More outdoor unit diagnostic codes, including IPM and 4-way valve faults.
Troubleshooting for overload conditions in cooling and heating modes.
Explanation of fault codes displayed via LED lamps and 7-segment display for 24-36k units.
Detailed table of drive faults, reasons, and troubleshooting steps for 24-36k units.
Diagnostic codes related to sensor faults and unit turn-off conditions.
Flowchart for testing the refrigeration system in cooling mode, including superheat checks.
Flowchart for testing the refrigeration system in heating mode, including pressure checks.
General safety warnings and information about R-410A refrigerant systems.
Procedures for replacing a compressor, including safety and testing steps.
Specific steps for compressor replacement following a burnout, including system flushing.
Detailed procedure for the triple evacuation process of the refrigerant system.
Instructions on how to weigh and charge refrigerant, including additional charge calculation.
