Friedrich CP05 - Air Conditioner Installation Guide; Window Installation Requirements; Required Installation Hardware

Installation Instructions
Window Requirements
NOTE:All supporting parts should be firmly secured to wood, or metal.
1.This unit is designed for installation in standard double hung windows with actual opening widths of
22" to 36". The upper and lower sash must open sufficiently to allow a clear vertical opening of 14"
from the bottom of the sash to the window sill.
2.If stormwindow presents interference, fasten a 2" wide wood strip (OUTER SILL) to the inner
window sill across the full width of the sill. The wood strip should be thick enough to raisethe height
of the window sill so that the unitcan be installed without interference by the storm window frame.
See Fig. 5-2. Top of wood strip should be approximately 3/4" higher than the stormwindow frame
(STORM WINDOW FRAME) or wood strip (OUTDOORS) to help condensation to drain properly to
the outside.
3. Install a second wood strip (approximately 6" long by 11/2"wide and same thickness asfirst strip) in
the center of the outer sill flush against the back off the inner sill. This will raise the L bracket as
shown Fig. 5-2.
4. If the distance between STORM WINDOW FRAME and WOOD STRIP MOUNTED ON TOP OF
INNER SILL is more than 1",two of wood strip are not necessary.
L BRACKET
/
INNER WOOD STRIP MOUNTED 1" MAX. J
SILL ON TOP OF INNER SILL _ 3/4" i
CLEARANCE
INDOORSq Fig. 5-1
ER
lU OUTDOORS
INNER
SILL
INDOORS
WOOD STRIP
FOR L BRACKET
Fig. 5-2
...............STORM
WINDOW
FRAME
\
OUTER
SILL
OUTDOORS
Installation
HARDWARE I
TYPEA: 1lEA
(SHORT SCREW)
TYPE D: 1EA TYPE F: 2EA
(SEAL STRIP) (GUIDE PANEL)
(Adhesive backed)
TYPE B: 5EA
(WOOD SCREW)
TYPE E: lEA
(SASH SEAL)
(Notadhesivebacked)
TYPE C: 3EA
(L BRACKET)
©
TYPE G: ! EA
(SUPPORT BRACKET)