Usi:ttpz Dehumidifier
PAN FULL
0
HUMIDISTAT
15 pint model
This model does not have an On/Oft Switch, a
De-leer Control or a Humidistat.
l
To turn unit on-plug power supply cord into
electrical outlet. Be sure to use the correct
grounding technique. (See page 4.)
l
To turn unti off-unplug power supply cord
from electrical outlet.
NOTE: This unit may or may not have a water
level control. (Refer to the diagram on page 9.)
l
lf your model has a water level control switch, it
will automatically turn the unit off when the pan
is full. You can adjust the level of water
collected in the pan. (See Setting the water
level adjustment” on page 9.)
l
lf your unit does not have a water level control
switch, the pan should be checked often and
emptied when it is 54 to % full. You may also
choose one of the alternate water disposal
methods described on page 9 in “Water
disposal methods.”
Do not operate dehumidifier d tempers-
tures below 16.3% (65’F). The coils msy
become iced over and unit will not operate
pwerly.
25,30, 40 and 50 pint models
Control panel
These units have a control panel containing two
controls-the Pan Full Light and the Humidistat.
Pan Full Light-This light glows when the water
pan is full and needs to be emptied.
Humidistat-This controls the amount of moisture
left in the room. When the humidity in the room
increases, the unit automatically starts. When the
humidity decreases to the selected level, the unit
automatically stops. The unit will run constantly
when control is set to DRYEST.
To Next Page
Loading...
