Introduction for buttons on remote controller
●
●
●
In DRY mode fan speed is set only to low speed, for maximum dehumidification.
4
▲ / button
▲
▲
Press / button to increase/decrease set temperature. In AUTO mode, set
temperature is not adjustable. When setting Timer On or Timer Off, press "▲"
▲
or " " button to adjust the time.
Note:
Once power is supplied to unit, unit will chime.
Operation indicator " " is ON (red indicator, the colour is different for different
models). After that, you can operate the air conditioner by using remote controller .
In operation mode, button presses on the remote will cause the " " to blink. This
means that the remote is sending signals to the unit. The air conditioner responds
to button presses with a chiming sound.
In stand-by mode, set temperature and clock icon will be displayed on the display
of remote controller (If timer on, timer off and light functions are set, the corre-
sponding icons will be displayed on the display of remote controller at the same
time); Under on status, the display will show the corresponding set function icons.
1
On/Off button
Press this button to turn on the unit. Press this button again to turn off the unit.
2
Mode button
Each time you press this button, a mode is selected in a sequence that goes from
AUTO, COOL, DRY, FAN, and HEAT , as the following:
AUTO COOL DRY FAN
HEAT*
●
3
Fan button
This button is used for setting Fan Speed in the sequence that goes from AUTO,
, to , then back to Auto.
Note:
▲
To Next Page
Loading...
