Introduction for buttons on remote controller
1.
signal sender battery
reinstall
2. Replace two 7# (AAA 1.5V) dry batteries, and
remove
3. Reinstall the cover of battery box.
Cover of battery box
1
12
Light button
Press this button to
turn on the display's light and press this button again to turn
off the display's
light.
Function introduction for combination buttons
"
▲
Combination of "MODE" and " " buttons:
▲
About switch between F° and C°
At unit OFF, press "MODE" and " " buttons simultaneously to
▲
switch between ć and .
Combination of "TEMP" and "TIMER" buttons:
Energy-saving Function
Press "TEMP" and "TIMER" simultaneously in COOL mode to start energy-saving function.
Indoor unit displays
"
SE
"
. Repeat the operation to quit the function.
Combination of "TEMP" and "TIMER" buttons:
About 46° F
Heating Function
Press "TEMP" and "
TIMER
" simultaneously in HEAT mode to start 46° F
Heating Function
indoor unit displays
"
"
and a selected temperature of
"
46° F
"
.
(8° C if Celsius is adopted). Repeat the operation to quit the function.
Replacement of batteries in remote controller
Press the back side of remote controller marked
the cover of battery box along the arrow direction.
make sure the position of "+" polar and "-" polar
are correct.
Combination of
▲
" and " " buttons: Remote Control lock
▲
Press " " and " "
▲
buttons simultaneously 3s to lock or unlock the keypad. If the remote
controller is locked, is displayed. In this case, pressing any button, blinks
three times.
To Next Page
Loading...
Need help?
General
