Friedrich MRM36Y3J - Installation of indoor unit


Step two: install ZDOOEUDFNHW
Installation of indoor unit
Step one: choosing installation location
 +DQJZDOOEUDFNHWLQVWDOOFHQWHUVFUHZDQGDSSO\OHYHO
 ,IUHTXLUHGSUHGULOOLQWKHORFDWLRQV\RXYHFKRVHQIRUPRXQWLQJLQVWDOOUHTXLUHG
PRXQWLQJKDUGZDUHDQGVHFXUHWRZDOO
1.
Choose the position of piping hole according to the direction of outlet pipe. The
position of piping hole should be a little lower than the wall-mounted frame,
shown as below.
Step three: open piping hole
 'ULOOKROHWKURXJKZDOOZLWKDGLDPHWHURIRQWKHVHOHFWHGORFDWLRQ.In
order to drain smoothly, slant the hole on the wall slightlydownward to the
outdoor side with the gradient of 5-10°.
Left
Wall
ĭ
Right
Rear piping hole
Wall
ĭ
Rear piping hole
Space
to the
wall
above
LQ
Space
to the
wall
above
LQ


Mark FHQWHUORFDWLRQ
Level