Friedrich UE08A13A User Manual

—17—
3.3 PROCEDURE A
If you are using the new LGE sleeve supplied with
your unit, skip to step 3. Otherwise, install the
plastic grille from the kit. Cut the plastic grille to 25-
1/2" wide and 15-1/4" high. Place the plastic grille
to the inside of the wall sleeve at the rear flange.
Fasten the 4 washer screws to secure the grille to
the wall sleeve. If you need plastic nuts to mount
plastic grille to the inside of the wall sleeve, there
are plastic nuts in the installation kit. The nuts are
installed from the inside of the sleeve and are
pressed into the square holes of the rear flanges.
Remove the backing from the Horizontal Insulation
strip 1
3
/
8
x
3
/
8
x 27
3
/
16
and attach that to the inside
bottom of the sleeve as shown below. Remove the
backing from the Around Insulation strip 1
3
/
8
x
3
/
4
x
61
1
/
2
and attach that to the inside front of the
sleeve as shown below.
Install the new unit into the wall sleeve.
To assemble trim, snap the tab of each piece into
the slot of the other piece as shown below. Slide
trim over the front of the air conditioner until trim is
flush with sleeve as shown below.
FIG. 21
Around Insulation
Horizontal Insulation
FIG. 23
or
FIG. 22
1
2
3
4
5
Wall
Trim (2 ea)
FIG. 24
• Air conditioners covered in this manual pose
an excessive weight hazard. Two or more
people are needed to move and install the
unit.
To prevent injury or strain, use proper lifting
and carrying techniques when moving unit.
• When handling the air conditioner, be careful
to avoid cuts from sharp metal fins on front
and rear coils.
• Make sure air conditioner does not fall during
removal.
CAUTION

Friedrich UE08A13A Specifications

General

Brand	Friedrich
Model	UE08A13A
Category	Air Conditioner
Language	English