1.5.2 COOLING AND HEATING MODEL
• OPERATION
—7—
A slight burning odor may come from the unit
when first switching to HEAT after the cooling
season is over. This odor, caused by fine dust
particles on the heater, will disappear quickly.
This is normal operation.
Off - Turns the air conditioner off.
Fan Only - The low fan speed operation without cooling (heating).
Low Cool - Cooling with the low speed fan operation.
High Cool - Cooling with the high speed fan operation.
Low Heat - Heating with the low speed fan operation.
High Heat - Heating with the high speed fan operation.
Turn the Temperature Knob to the desired setting. The central position is a normal
setting for average conditions. You can change this setting, if necessary, in
accordance with your temperature preference.
The thermostat automatically controls cooling or heating, but the fan runs
continuously whenever the air conditioner is in operation. If the room is too warm,
turn the thermostat control clockwise. If the room is too cool, turn the thermostat
control counterclockwise.
When the air conditioner has been operated in the
cooling or heating mode and is turned off or set to the fan
position, wait at least 3 minutes before resetting to the
cooling operation again.
CAUTION
To Next Page
Loading...
