Frigidaire ATF6000FS1 User Manual

Full Size Tumble Action Washers
Before beginning installation, carefully read these instructions. This will simpfify the
installation and ensure the washer is installed correctly and safely. Leave these instructions
near the washer after installation for future reference.
NOTE: The electrical service to the washer must conform with local codes and ordinances
and the latest edition of the National Electrical Code, ANS!/NFPA 70.
For your safety the information in
this manual must be followed to minimize the risk
of fire or explosion or to prevent property damage,
personal injury or loss of life.
- Do not store or use gasoline or other flammable
vapors and liquid in the vicinity of this or any
other appliance.
- WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not
use any phone in your building.
• Clear the room, building or area of all
occupants.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas suppliers
instructions.
• If you cannot reach your gas supplier, call
the fire department.
Installation and service must be performed by a
qualified installer, service agency or the gas
supplier.
Printed in U.S.A.
Contents
S UBJECT PAGE
Pre-lnstallation Requirements 2
Electrical Requirements 2
Grounding Requirements 2
Water Supply Requirements 2
Drain Requirements 2
Rough-In Dimensions 3
Location Of Your Washer 4
Unpacking 4-5
Installation B-6
Replacement Parts 6
WN 134905800(0707)

Frigidaire ATF6000FS1 Specifications

General

Brand	Frigidaire
Model	ATF6000FS1
Type	Washer
Capacity	3.5 cu. ft.
Color	White
Energy Star Certified	Yes
Voltage	120 V
Width	27 inches
Water Level Settings	Auto
Height	36 inches
Loading Type	Front Loading

Summary

Pre-Installation Requirements

Tools Required for Installation

Lists all the necessary tools required to successfully install the washing machine.

Electrical Requirements

Circuit and Power Supply

Specifies the required circuit amperage, voltage, phase, and frequency for safe operation.

Outlet Receptacle

Details the proper type and placement of the grounded electrical outlet.

Grounding Requirements

Importance of Grounding

Explains why proper grounding is critical to prevent electrical shock.

Water Supply Requirements

Faucet and Pressure Specifications

Details the type of faucets, hose size, and water pressure range needed.

Drain Requirements

Drainage Specifications

Outlines the minimum drain flow rate, standpipe diameter, and height.

Rough-In Dimensions

Washer Dimensions and Clearances

Provides detailed measurements for side, back, and installation clearances.

Location of Your Washer

Installation Site Selection

Guides on choosing a suitable location, avoiding hazards and ensuring proper conditions.

Floor and Clearance Requirements

Specifies floor stability, slope limits, and minimum installation clearances.

Unpacking the Washer

Removing Shipping Materials

Instructions for safely removing the shipping carton, base, and securing components.

Washer Installation Steps

Leveling the Washer

Procedure for adjusting the leveling legs to ensure stability and quiet operation.

Connecting Water Hoses

Detailed steps for attaching and tightening the hot and cold water inlet hoses.

Attaching the Drain Hose

Instructions for securing the drain hose to the standpipe or other drain.

Connecting Power and Final Checks

Steps for plugging in the power cord, turning on power, and running a test cycle.

Replacement Parts and Accessories

Pedestal Installation Note

Information regarding the use and installation of an optional pedestal accessory.

Ordering Replacement Parts

Guidance on how to obtain necessary replacement parts for the washer.