Note: The time of must first be set in order to the
day
operate
oven.
To set the Clock
When the range is first plugged in, or when the power supply to the appliance has been interrupted, the display willflash "12:00".
/_i_Jck_'_ (do not hold pad down).
1. Press,,or%j once
2. Within 5 seconds, push and hold A or M' until the correct time of day appears in the display.
; Clock +_
3. Press ......!!_j\_or,o_oto accept the new time of day. If \_t[lo_!!_:jis not pressed, the timer will return automatically to the new time of
day after 7 seconds.
Note: The clock cannot be changed during any bake, timed bake, delayed time bake, clean cycle or delayed clean cycle.
Changing
1.
2.
3.
4.
between 12 or 24 Hour Time of Day Display
Press and hold !_-J_#o}for 7 seconds. After 7 seconds, "12Nr" or "24N r" will appear inthe display and the control will beep
once.
H_
Press A or V to switch between the 12 and 24 hour time of day display. The display will show either "12Hr" or "24Hr".
Wait 5 seconds or press to return to the time of day display.
Reset the correct time as described in To set the Clock above. Please note that ifthe 24 hourfime of day mode was chosen,
the clock will now display time from 0:00 through 23:59 hours.
To Set the Minute Timer
1. Press Lo,,_of_.
_Jinuteri_
2. Press A to increase or V to decrease the time in one minute increments. The timer can be set for any amount of time
from 1 minute to 11 hours and 59 minutes.
3. Thedisplayshowsthetimercountdowninminutesifmorethanl hourremains.Whenlessthanl hourremains,thedisplay
will count down in seconds.
4. When the set time has run out, the timer will beep 3 times. It will continue to beep 3 times every 8 seconds until _i,1,_f/is
pressed.
Note: The indicator light located above the TIMER ON/OFF pad will glow while the minute timer is active.
Note: The minute timer does not start or stop cooking. Itserves as an extra timer in the kitchen that will beep when the set time
has run out. The minute timer can be used alone or during any of the other oven functions. When the minute timer isin use with
any other mode, the minute timer will be shown in the display. To view other functions, press the function pad for that mode.
To Cancel the Minute Timer before the set time has run out: Press _o,,Jof,_
_,_,,,o_.
For a silent control panel
When choosing a function, a beep will be heard each time a pad is pushed. If desired, the controls can be programmed for silent
operation.
_i_'.i,t_i_for 7 seconds, or "SP" appears in the display.
To tell ifyour oven is set for normal or silent operation push and hold ,o,_o,,o %="
Within 5 seconds, press A or V to switch between normal sound operation and silent operation mode. The display will show
either %="or"SP". Wait 5 seconds to return to normal operating mode. Note: If"SP" appears, the control will operate with normal
sounds and beeps. If %-" appears, the control is in the silent operation mode.
Temperature Conversion (Fahrenheit / Celsius)
The electronic oven control is set to operate in °F (Fahrenheit) when shipped from the factory. The oven can be programmed
for any temperature from 170°F to 550 °F (77°C to 288°C).
To change the temperature to °C (Celsius) or from °C to °F (control should not be in a Bake or Clean mode):
{
1. Press and hold ,or 7 seconds until °F or °C appears in the display.
2. PressAor Vt° change °Fto °C or °C to °F.
3. Wait 5 seconds to accept the changes or press / o,,Jofdto accept the changes.
To Next Page
Loading...
