7USING YOUR ICE MAKER
1. Before clean procedure, please make sure the water drain cap has been inserted
into the appliance; otherwise it will not work properly.
2. Press “ICE/CLEAN” button for 5 seconds, Ring indicator light flashes white, it will
run cleaning procedure for 15 minutes and automatically exit, press this button
again during the cleaning procedure, it will exit immediately.
3. After cleaning procedure, remove the top cover and the ice basket, rinse the main
water reservoir and the secondary water reservoir, then move the appliance to the
edge of the desktop, make sure that the appliance is placed steady, place a water
container under the appliance, remove drain cap from the bottom, dirty water will
drain into the water container, then reinsert the drain cap.
For the first time, or the clean procedure has not been running for a long time,
it is highly recommended to run this procedure at first.
Ice baslet
Top cover
Secondary
water reservoir
Water reservoir
Water drain cap
1. Remove the top cover, and take out the power cord.
2. Take out the ice basket, pour potable water into water reservoir, 0.3-gallon
water at most at one time.
3. Put back the ice basket.
4. Plug in and the ring indicator will red light on. If you press the “Ice /Clean”
button, the machine will start making ice; If long press the “Ice/Clean” button,
it will do automatic cleaning.
Pour Water
EN
To Next Page