12
Ring indicator light
flashes red.
Making Ice too slowly.
Water leakage.
Water temperature in
inner tank is too high.
Water temperature
requirement between
44.6°F -89.6°F.
Refrigeration system
malfunctions.
Verify by a qualified
technician.
Put the drain plug in place.
Ambient temperature or
water temperature in
inner tank is too high.
Please run the ice maker
below 90 Fahrenheit
degree ambient and pour
colder water into tank.
Refrigerant liquid leakage.
Drain plug not in place.
Cover motor is broken.
Pipe in the cooling system
is blocked.
Press the ICE button twice,
restart ice making program,
if this problem show up
again, verify by a qualified
technician.
Hot Air outlet has been
blocked by something.
Hot Air outlet must be
guaranteed to have more
than 15 CM of ventilation
distance.
Pipe Joint in the appliance
may loose.
Verify by a qualified
technician.
The seal has reached
service life.
Verify by a qualified
technician.
PROBLEM POSSIBLE CAUSES SOLUTION
“ADD WATER”
indicator light turns on.
Lack of Water.
Stop the ice maker, fill
water, and press “ICE/
CLEAN” button again
to restart the unit.
Suggest you to obtain the
ice-cube.
Remove the probable
obstacle inside or clean
the inside wall of the ice
storage.
No ice cube inside.
There is too much ice.
“ICE FULL” indicator
is on.
TROUBLESHOOTING GUIDE
EN
To Next Page