DOOR REMOVAL INSTRUCTIONS
DOOR REMOVAL AND REVERSAL INSTRUCTIONS:
1 Remove dispensing tower from unit.
2 Remove three (3) screws at rear edge of top cover, then lift up at rear and slide forward to
remove cover (see Figure A).
3 Remove two (2) screws from top door hinge and lift up out of door bushing (see Figure B).
6 Re-install door with LH bushing placed over hinge pin.
7 Re-install top hinge on opposite corner of cabinet and then assemble top cover in reverse
order of Step 2.
NOTE: The direction in which your unit door opens (door swing) can be reversed,
from left to right or right to left, by moving the door hinges from one side to the
other. Reversing the door swing should be performed by a qualified person.
IMPORTANT: Before you begin, turn the unit temperature control to “OFF” and
remove the electrical power cord from the wall outlet. Remove any food from door
shelves.
12
To Next Page
Loading...
