4.
•
Electrical connection
"Warning H
Improper use of the grounded plug can result in the risk of electrical
shock. If the power cord is damaged, have it replaced by an authorized
service technician.
This appliance should be properly grounded for your safety. The power cord
of this appliance is equipped with a three-prong plug which mates with
standard three-prong wall outlets to minimize the possibility of electrical
shock.
Do not under any circumstances cut or remove the third ground prong from
the power cord supplied.
Plug the appliance into an exclusive, properly installed, grounded wall outlet.
Any questions regarding power and/or grounding should be directed toward a
certified electrician or an authorized Summit service center.
It is recommended that a separate circuit serving only this appliance be
provided. Use a receptacle that cannot be turned off with a switch or pull
chain.
The use of extension cords is strongly discouraged.
This appliance requires a standard 115/120-volt, 60 Hz electrical outlet with
three-prong ground and a 15-amp fuse. To prevent accidental injury, the
power cord should be secured behind the appliance and not left exposed or
dangling.
NOTE: Before performing any type of installation, cleaning or removing a light bulb,
turn the thermostat control to OFF and then disconnect the unit from the
electrical power source. When you are finished, reconnect the freezer to the power
source and reset the temperature control to the desired setting.
Operation
I. Before the freezer is plugged in, check the following:
-There must not be any damage on all electrical wire.
-Earthing screw must be well fixed.
-Wall outlet must be properly earthed.
Be sure that everything is in normal condition and the freezer can be plugged in.
2. When operating for the first time
When operating is in normal condition and the freezer without any load until it
auto stops at the desired temperature, usually it takes 2 or 3 hours. Then set the
thermostat to the required setting and place foods in.