Installation
Before using
Unpack the appliance and check if there are damages on it. Do not connect
the appliance if it is damaged. Report possible damages immediately to the
place you bought it. In that case retain packing.
It is advisable to wait at least four hours before connecting the appliance to
allow the oil to flow back in the compressor.
Adequate air circulation should be around the appliance, lacking this leads to
overheating. To achieve sufficient ventilation follow the instructions relevant to
installation.
Wherever possible the spacers of the product should be against a wall to
avoid touching or catching warm parts (compressor, condenser) to prevent
possible burn.
The appliance must not be located close to radiators or cookers.
Make sure that the mains plug is accessible after the installation of the
appliance
Space requirement
The following are recommended.
Clearances around the chest
freezer:
Sides: 10cm
Back: 10cm
Top: 70cm
Location
The appliance should be installed well away from sources of heat such as
radiators, boilers, direct sunlight etc. Ensure that air can circulate freely around
the back of the cabinet. To ensure best performance, if the appliance is
positioned below an overhanging wall unit, the minimum distance between the
top of the cabinet and the wall unit must be at least 100 mm. Ideally, however,
the appliance should not be positioned below overhanging wall units. Accurate
leveling is ensured by one or more adjustable feet at the base of the cabinet.
Positioning
Install this appliance at a location
where the ambient temperature
corresponds to the climate class
indicated on the rating plate of the
appliance:
For electrical connection carefully follow the instructions given in specific
paragraphs.
It must be possible to disconnect the appliance from the mains power supply;
the plug must therefore be easily accessible after installation.
Electrical connection
Before plugging in, ensure that the voltage and frequency shown on the rating
plate correspond to your domestic power supply. The appliance must be
earthed. The power supply cable plug is provided with a contact for this
purpose. If the domestic power supply socket is not earthed, connect the
appliance to a separate earth in compliance with current regulations, consulting
a qualified electrician.
The manufacturer declines all responsibility if the above safety precautions are
not observed.
This appliance complies with the E.E.C directives.
70 cm
10 cm
10 cm
Climate class Ambient temperature
SN
N
ST
T
+10 °C to +32 °C
+16 °C to +32 °C
+16 °C to +38 °C
+16 °C to +43 °C
Attention
Attention
23 24
ENG
ENG
To Next Page
Loading...
