Troubleshooting
Before troubleshooting, disconnect the power supply. Only a qualified
electrician of competent person must do the troubleshooting that is not in this
manual.
There are some sounds during normal use (compressor, refrigerant
circulation).
•Mains plug is not plugged in or is
loose.
•Fuse has blown or is defective
•Socket is defective.
Appliance does not
work
•Insert the main plug.
•Check fuse, replace if necessary.
•Main malfunctions are to be
corrected by an electrician.
Appliance freezes
too much
•Temperature is set too cold or the
appliance runs at MAX setting.
•Turn the temperature regulator to
a warmer setting temporarily.
•Temperature is not properly
adjusted.
•Door was open for an extended
period.
•A large quantity of warm food
was placed in the appliance
within the last 24 hours.
•The appliance is near a heat
source.
The food is not
frozen enough.
•Please look in the initial
Temperature Setting section.
•Open the door only as long as
necessary.
•Turn the temperature regulation
to a colder setting temporarily.
•Please look in the installation
location section.
•Door seal is not air-tight.
Heavy build-up of
frost on the door
seal.
•Carefully warm the leaking
sections of the door seal with a
hair dryer (on a cool setting). At
the same time shape the warmed
door seal by hand such that it sits
correctly.
•The appliance is touching the
wall or other objects.
•A component, e.g. a pipe, on the
rear of the appliance is touching
another part of the appliance or
the wall.
Unusual noises
•Move the appliance slightly.
•If necessary, carefully bend the
component out of the way.
If the malfunction shows again, contact the Service Center.
These data are necessary to help you quickly and correctly. Write the
necessary data here, refer to the rating plate.
Problem Possible cause Solution
Attention
Attention
Attention
31 32
ENG
ENG
To Next Page
Loading...
