Cleaning and maintenance
For hygienic reasons the appliance interior, including interior
accessories, should be cleaned regularly.
Before maintenance, switch off the appliance and disconnect the mains plug
from the mains socket.
Do not clean the appliance with metal objects.
Do not use sharp objects to remove frost from the appliance. Use a plastic
scraper.
Regularly examine the drain in the chest freezer for defrosted water. If
necessary, clean the drain.
Cualquier trabajo eléctrico necesario para hacer el mantenimiento del aparato
debe ser realizado por un electricista o técnico especializado.
Este aparato debe ser reparado por un centro de servicio autorizado, y sólo
piezas de repuesto originales deben ser utilizados.
The appliance may not be connected to the mains during cleaning. Danger of
electrical shock! Before cleaning switch the appliance off and remove the plug
from the mains, or switch off or turn out the circuit breaker or fuse. Never
clean the appliance with a steam cleaner.
Moisture could accumulate in electrical components, danger of electrical
shock! Hot vapors can lead to the damage of plastic parts. The appliance
must be dry before it is placed back into service.
Ethereal oils and organic solvents can attack plastic parts, e.g. lemon
juice or the juice form orange peel, butyric acid, cleanser that contain
acetic acid.
• Do not allow such substances to come into contact the appliance parts.
• Do not use any abrasive cleaners
• Remove the food from the freezer. Store them in a cool place, well covered.
• Switch the appliance off and remove the plug from the mains, or switch off or
turn out the circuit breaker of fuse.
• Clean the appliance and the interior accessories with a cloth and lukewarm
water. After cleaning wipe with fresh water and rub dry.
• Accumulation of dust at the condenser increases energy consumption. For
this reason carefully clean the condenser at the back of the appliance once a
year with a soft brush or a vacuum cleaner.)
• After everything is dry place appliance back into service.
Defrosting of the freezer
The freezer, however, will become progressively covered with frost. This should
be removed.
Never use sharp metal tools to scrape off frost from the evaporator as you
could damage it.
However, when the ice becomes very thick on the inner liner, complete
defrosting should be carried out as follows:
01. Unplug the unit. Remove the drain
plug from the inside of the freezer.
Defrosting usually takes a few
hours. To defrost faster keep the
freezer door open.
02. For draining, place a tray beneath
the outer drain plug. Pull out the
drain dial.
03. Rotate the drain dial 180 degree.
This will let the water flow out in
the tray. When done, push the
drain dial in. Replug the drain plug
inside the freezer compartment.
Note: monitor the container under
the drain to avoid overflow.
04. Wipe the interior of the freezer
and replace the electrical plug in
the electrical outlet.
05. Reset the temperature control to
the desired setting.
Hole
Attention
29 30
ENG
ENG
To Next Page
Loading...
