SERVICE DATA SHEET
P/N: FFPD1821
Electronic Series
Color Code
BK............. Black
BL............. Blue
BN............ Brown
P................ Purple
R............... Red
W........... White
R/Y..... Red/Yellow
Y............. Yellow
Wiring Diagram
Display Codes (LED)
Close and latch door. Press START/CANCEL pad.
----------------------Wash portion of cycle.
------------------------ Shows completion of cycle. Indicator light will switch off when door is opened.
-- HI-TEMP WASH and NO HEAT DRY/POWER DRY OFF LED's flashing indicates power failure has occurred. Press START/CANCEL
pad and reselect desired options and cycle.
-- The STATUS LED's that are lit when the door is opened will flash. Close door.
This information is intended for use by
persons having electrical and
mechanical training and a level of
knowledge of these subjects generally
considered acceptable in the appliance
repair trade. Electrolux Home Products
North America cannot be responsible,
nor assume any liability, for injury or
damage of any kind arising from the
use of this Service Data Sheet.
Operation
The water/service test is a special
function initiated from the power
failure mode or idle mode.
While in power failure or idle mode -
simultaneously press the AIR DRY and
START/CANCEL pads for 1 1/2 seconds.
The dishwasher will then step through
the test cycle per the chart. Pushing the
START/CANCEL pad will advance the
dishwasher to the next step.
Water/Service Test
30
45
.4
75
60
90
30 1
0
0
0
0
0
0
0
1
0
1
0
0
1
0
0
0
0
1
1
0
0
1
1
1
0
X
1
0
1
0
1
0
0
0
1
1
1
1
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
1
0
1
2
3
4
STEP
TOTAL TIME (SEC)
WATER VALVE
CIRCULATION MOTOR
DRAIN MOTOR
HEATER
DISPENSER
FAN UNIT
SANITIZE LED
CLEAN LED
FILL/DISPENSER
DISPENSER
WASH/HEAT
PAUSE
WASH/HEAT
WASH/HEAT/DISP
DRAIN/DRY
DRY
CLEAN LED stay on for 30 seconds after door is opened or cycle started.
X - denotes selectable option
5
6
8
0
0
0
0
0
0
00
7
90
Device being monitored
Display flashes when
detection of failure
THERMISTOR
Hi temp wash
Cycle Selection Options
To Previous Page
Loading...
