To Next PageTo Next Page
Need help?Do you have a question about the Frigidaire FGBM19WNVDA and is the answer not in the manual?
General| Type | Over-the-Range Microwave |
|---|---|
| Capacity | 1.9 cu. ft. |
| Power | 1000 Watts |
| Height | 16.5 inches |
| Color | Stainless Steel |
| Control Type | Electronic Touch |
| Turntable | Yes |
| Sensor Cooking | Yes |
| Child Lock | Yes |
| Voltage | 120V |
| Width | 29.875 inches |
| Depth | 15.5 inch |
| Ventilation | 2-Speed Fan |
| Cooking Modes | Defrost |
| Exterior Dimensions (W x D x H) | 29.875 x 15.875 x 16.5 inches |
Important initial steps and information before starting the installation process.
Critical safety warnings and precautions to prevent injury or damage during installation.
Specifications for the power supply, circuit, and wiring needed for the microwave.
Guidance on handling shipment damage and a list of included parts.
List of necessary tools and dimensions required for the microwave's installation space.
Steps for unpacking the microwave and preparing the mounting plate for installation.
Locating wall studs and aligning the mounting plate using templates and measurements.
Guidance on positioning the wall plate based on different cabinet bottom configurations.
Detailed steps for accurately aligning the mounting plate on the wall for installation.
Instructions for setting up the microwave for non-vented, recirculating air operation.
Steps for venting the microwave exhaust horizontally through the back wall.
Instructions for venting the microwave exhaust vertically through the top.
Steps for securely attaching the mounting plate to the wall for recirculating installation.
Guidance on using the template to prepare the top cabinet for cord and mounting holes.
Procedure to verify the correct installation of the blower plate on the unit.
Instructions for lifting and securing the microwave oven to the top cabinet.
Steps for replacing or installing a charcoal filter in models that support it.
Example calculation for external top exhaust ductwork length and components.
Example calculation for external back exhaust ductwork length and components.
Steps for preparing the rear wall by cutting an opening for the outside exhaust.
Instructions for securing the mounting plate to the wall using toggle bolts.
Using the template for preparing the top cabinet for mounting and cord passage.
Modifying the microwave blower unit for proper connection to the external exhaust.
Detailed steps for lifting and securing the microwave oven into its installed position.
Steps for attaching the mounting plate to the wall for vertical top exhaust installation.
Using the template for preparing the top cabinet for exhaust cutout and cord passage.
Modifying the blower unit for connection to the vertical top exhaust system.
Ensuring the damper operates correctly before and after microwave installation.
Steps for lifting and securing the microwave oven to the top cabinet.
Adjusting the exhaust adaptor for proper connection to the house ductwork.
Guidance on connecting and sealing the exhaust ductwork to the adaptor.
Steps to verify installation, connect power, and prepare for initial use.
Instructions for keeping documentation and completing product registration.
