Your dishwasher cleans by spraying a mixture of hot water and detergent through the spray arms against soiled surfaces.
Next, the dishwasher fills with water covering the filter area. Water is then pumped through the filter and spray arms. Soil
particles go down the drain as the water is pumped out and replaced with clean water. The number of water fills will vary
with the cycle being used.
Upper Spray Arm
Blower Vent
Assembly
Bowl Tines
Middle SprayArm
Adjustable Upper Rack
Tub Gasket
Glass Tra
Overfill Protector
\
Detergent Dispenser_
Vent
Getting Started
1. Load dishwasher (See Preparing and Loading
Dishes).
2. Add detergent (See Dishwasher Dispenser &
Detergents).
3. Add rinse aid (See Rinse Aid).
4. Select desired CYCLE(See Cycle Chart). The
indicator light above the pad will glow when selected.
5. Select desired OPTIONS (See Energy Options). The
indicator light above the pad will glow when selected.
6. Run hot water faucet nearest dishwasher until water is
hot. Turn water off.
7. To start, press START/CANCEL pad.
8. Close door to latch.
The dishwasher is programmed to remember your last cycle
soyou do not have to reset each time. To start the
dishwasher using the same cycle and options selected on the
To Next Page
Loading...
