Operating Instructions
Operating Instructions
(continued)
If the display reads "AS" , a sensor has failed. Contact your
Authorized Frigidaire Service Center.
FAULT CODES:
Note: This feature is a reminder to clean the Air Filter (See
Care and Cleaning) for more efficient operation. The LED
(light) will illuminate after 250 hours of operation. To reset
after cleaning the filter, hold the " reset filter" button 3
seconds and the light will go off.
CHECK FILTER FEATURE, YOU WILL SEE:
DO THIS:
HOLD RESET FILTER
BUTTON 3 SECONDS
If the display reads "ES" , a sensor has failed. Contact your
Authorized Frigidaire Service Center.
FAULT CODES:
10
.devreser sthgir llA.cnI ,stcudorP emoH xulortcelE 9002
TO CHANGE TEMPERATURE DISPLAY:
Note: The control is capable of displaying temperature in
degrees Fahrenheit or degrees Celsius.
YOU WILL SEE:
DO THIS:
PRESS AND HOLD THE
UP/DOWN BUTTONS
SIMULTANEOUSLY FOR 3 SECONDS
After 60 seconds of control inactivity the display and indicator lights will turn off. Press any button on the control panel or remote
control and the display will resume. Please note that if the unit is in eco mode and the set temperature has been reached the unit
may appear off. However, the unit is on and will continue to sample the air every 10 minutes. To confirm, press any button on the
control panel or remote control to illuminate the display to show unit in eco mode.
DIMMING DISPLAY:
To Next Page
Loading...
Need help?
General
