19
Unpacking instructions
1. If foam tub block has been removed,
reinsert it now and tape the lid securely.
2. Carefully cut the front and back
corners of the left side of the
remaining cardboard.
3. With help from a second person,
carefully tip the laundry center slightly
to the left as shown in the picture
below. Remove the foam shipping
support from the base of the unit. Save
packaging foam for future use.
4. Carefully lower the laundry center to
an upright position and remove the
tape holding the lid shut. Remove the
foam tub block, all foam inserts, and
other tub contents.
5. From the back of the washer, remove
the wire shipping clips securing the
drain hose.
6. DO NOT remove the PLASTIC CLIPS
which secure the drain hose to the
right side of the washer back sheet.
It helps form a standpipe to prevent
water siphoning.
2
1
7. Carefully move the laundry center
to within four (4) feet of the
final location for the start of the
installation.
IMPORTANT
To prevent vibration, possible machine
damage and maximize performance,
the following steps must be completed.
NOTE
If the laundry center is to be
transported at a later date, the tub
blocking pad, foam base and tub
support should be retained.
CAUTION
EXCESSIVE WEIGHT HAZARD
To avoid back or other injury, have more
than one person move or lift the appliance.
INSTALLATION
To Next Page
Loading...
Need help?
General
Weight and Dimensions
